Home Prev Next Touchstone TM602 Telephony Modem User’s Guide 14
Getting Battery USB Ethernet
Safety Started Installation Installation Drivers Configuration Usage Troubleshooting Glossary
TM602G/H 4-cell Battery Installation and Replacement
Use this procedure to install or replace a 4-cell backup battery.
Action
1 Insert a finger into the latch opening, press down and pull back on the latch
holding the battery door (on the bottom of the Telephony Modem). Pull the
door toward you. Set the door aside in a safe place.
2 Hold the battery pack so that the guides on the battery align with the slots
on the Telephony Modem and slide the battery into the bay. The diagram on
the left shows the proper orientation.
Note: Batteries will not insert completely into the Telephony Modem if not
oriented correctly. The battery should slide into the bay without significant
force. Line up the slots in the battery bay with the guides on the battery and
apply even pressure on both ends of the battery.
WRONG WRONG RIGHT
Latch
End
Battery Slot
Battery Guide
Battery
Pull Strap
Hinge Tabs
Receiver
Slots
