Home Prev Next Touchstone TM602 Telephony Modem User’s Guide 13
Getting Battery USB Ethernet
Safety Started Installation Installation Drivers Configuration Usage Troubleshooting Glossary
3 Push the battery pack into the bay until it seats into place. The following di-
agram shows a Telephony Modem with a 2-cell battery pack installed. If you
are taking the battery out of the unit, position your finger in the bat-
tery opening area and use leverage to dislodge the battery while
pulling it straight back.
Note: The Telephony Modem will not begin operating until you apply AC
power.
4 Replace the door. To do so, place the hinge tabs of the battery door into the
receiver slots inside the Telephony Modem battery compartment on the op-
posite end of the battery opening slot. Rotate the door toward the unit until
the latch snaps back into place.
Note: Some Telephony Modem models use a Lithium-Ion battery pack.
Please recycle or dispose of the battery responsibly and in accordance with
local ordinances.
Battery
Opening
Receiver
Slots
Hinge Tabs
