Installing the Gateway
SURFboard® SBG6700-AC Wireless Cable Modem Gateway • User Guide
This product is for indoor use only. Do not route the Ethernet cable(s) outside
of the building. Exposure of the cables to lightning could create a safety
hazard and damage the product.
Connect the SBG6700-AC to Your Computer
Before installing the SBG6700-AC:
• Check with your service provider to ensure broadband cable service is available in your area.
To set up a wireless network, you will need a high-speed Internet connection provided by an
Internet service provider.
Note: When contacting your service provider, you may need your gateway information listed on the
gateway label located on the bottom of your SBG6700-AC (see Gateway Label).
• Choose a location in your home where your computer and gateway are preferably near existing
cable and electrical wall outlets.
For the best Wi-Fi coverage, a central location in your home or building is recommended.
Note: The following installation procedure covers the wired Ethernet connection process so that you can
confirm that the SBG6700-AC was properly installed and can connect to the Internet.
Figure 4 – SBG6700-AC Connection Diagram
