24
Malfunction Possible cause Remedy
1 short warning tone,
continuously repeated,
can be heard,
the cycle indicator for the
selected wash program is
flashing:
the control indicator
lights up:
fault code
Å10 is dis-
played in the multi-dis-
play:
(Problems with water in-
let)
Water tap is blocked with
limescale or is faulty.
Check the tap and have it
repaired, if necessary.
The tap is turned off. Turn on the tap.
The filter (where present) in
the threaded hose fitting
on the tap is blocked.
Clean the filter in the
threaded hose fitting.
Filters in the base of the
washing compartment are
blocked.
Press the button for the
dishwashing cycle that has
started;
then abort the dishwashing
cycle (see section: Starting
a dishwashing cycle);
clean filters (see section:
Cleaning the filters).
Water supply hose has not
been correctly positioned.
Check the position of the
hose.
2 short warning tones,
continuously repeated,
can be heard,
the cycle indicator for the
selected dishwashing cycle
is flashing,
fault code
Å20 is dis-
played in the multi-dis-
play. (Problems with water
outflow)
The sink outlet is blocked. Clean the siphon.
Water drain hose has not
been correctly positioned.
Check the position of the
hose.
3 short warning tones,
continuously repeated,
can be heard,
Fault code
Å30 is dis-
played in the multi-dis-
play.
The anti-flood system has
been triggered.
First shut off the water tap,
then switch off the appli-
ance and contact the Cus-
tomer Care Department.
The cycle is not starting.
The mains plug is not
plugged in.
Connect the plug to a mains
socket.
A fuse in the house’s wiring
system is defective.
Replace fuse.
For dishwasher models with
a delay start timer:
A start time has been se-
lected.
If the dishes are to be
washed immediately, cancel
the delay start.
