23
5. Remove the flat filter (3) from the
base of the washing compartment
and clean both surfaces thoroughly.
6. Re-insert the flat filter.
7. Place the fine filter in the micro-fil-
ter and fit the two together.
8. Insert the filter system in place and
lock it by turning the handle clock-
wise as far as it will go. Ensure that
the flat filter does not protrude
above the base of the washing com-
partment.
1 Under no circumstances may the dishwasher be used without its filters.
What to do if...
Remedying small malfunctions
If the acoustic signal is activated, warning tones sound if there are
faults.
If one of the following fault codes is displayed in the multi-display dur-
ing operation:
– Fault codeÅ10 (Problems with water inlet),
– Fault codeÅ20 (Problems with water drainage),
please have a look at the following table.
When the fault is remedied, press the button for the cycle that has
started. The cycle will continue.
With other fault codes (“Å ” followed by a number):
– Abort the dishwashing cycle.
– Switch the appliance off and on again.
– Re-set the dishwashing cycle.
If the fault is displayed again, please contact your local Service Force
Centre and inform them of the fault code.
