Do not overfill. The dispenser holds
3
oz.
(94
mL), or a capful of fabric soft-
ener.
The fabric softener is dispensed in the
rinse cycle. If 2nd Rinse is selected, the
fabric softener will be dispensed during
the 2nd Rinse.
Do not spill or drip any fabric softener
onto the clothes.
At the end of the cycle, a small amount
of water may be left in the dispenser.
This is normal.
NOTE:
Use only liquid fabric softener
in this dispenser.
5.
Closethewasherlid.
6.
Press POWER. This turns on the washer
display.
7.
Select a Wash Cycle. See "Cycles."
8.
Adjust the Modifiers, if desired. See "Modi-
fiers."
9.
Select desired Options. See "Options."
10. Select Delay Start, if desired. See "Delay
-~
Start" in the "Modifiers" section.
11.
Press START. The wash cycle begins, and
the display shows the estimated remaining
time. The lid will lock.
NOTE:
If you do not press Start within
5
minutes of pressing Power, the washer
automatically drains and shuts off.
PAUSING OR RESTARTING
THE WASHER
ADD A GARMENT
You can place additional clothing in the wash
when the "Add a Garment" status light is glow-
ing without sacrificing wash performance.
To add a garment or pause the washer at
any time:
1. Press STOP once.
To restart the washer:
1. Close the lid and press START.
2.
To unlock the lid after the Add a Garment
period, press STOP once. Pressing STOP
twice will cancel the wash cycle.
NOTE:
If the cycle is interrupted or if the lid is
left open for 30 seconds or more with water in
the tub, the pump will activate and drain the
tub.
STOPPING THE WASHER
You can stop the wash cycle and drain the tub
by pressing the Stop button twice or the Power
button once.
CHANGING CYCLES, MODIFIERS
AND OPTIONS
You can change Cycles, Modifiers and Options
anytime before Start is pressed. Not all Modifiers
and Options are available for all cycles.
A short tone sounds when a change is se-
lected.
Three short tones sound if an unavailable
combination is selected. The last selection
will not be accepted.
CHANGING CYCLES DURING
THE WASH CYCLE
1.
PressSTOPtwicetocancelthecycle.
2. Press POWER.
3.
Select the desired wash cycle.
4.
Select the desired Modifiers and Op-
tions.
5.
Press START.
The washer restarts at the beginning of the
new cycle.
NOTE:
If you do not press Startwithin
5
minutes
of pausing the washer, the washer automati-
cally drains and shuts off.
.2. Wait until the Lid Lock light turns off, then
open the lid.
3.
Add items.
