Connect the water supply hose(s)
• If your washing machine has one inlet hose and one inlet
valve on the back: connect to cold water supply only.
• If your washing machine has two inlet hoses and two
inlet valves on the back: connect to cold and hot water
supply, or to cold water supply only by using the Y-piece
connector. Both inlet valves must be connected to the
water supply. Observe the detailed instructions in your
programme chart.
1.
Carefully screw the hose connection onto the tap,
preferably by hand.
2.
Make sure there are no kinks in the hose.
3.
Check water-tightness of tap and appliance connections by
turning the tap completely on.
The appliance
must not be
connected to the mixing tap of a
non-pressurized water heater.
The appliance can be connected without a non-return valve.
If the flexible hose is damaged, unplug the appliance from
the mains immediately.
If the hose is too short, replace it with a longer length of
“Water Stop” hose (available from After-Sales Service or
specialist dealer).
Mount the new hose professionally on the washing machine
and the tap.
Note that the Aquastop/Water Stop safety function is no
longer guaranteed once the hose coating is damaged.
Connect the water drain hose
1.
Connect the drain hose to the ventilated siphon or hook it
over the edge of a sink with the “U” bend.
2.
Make sure there are no kinks in the hose.
3.
Secure the hose so that it cannot fall down while the
appliance is running.
Small wash-hand basins are unsuitable.
If you need to add an extension, use a hose of the same type.
Secure the connections with clips.
Max. drain hose length: 2.50 m
Max. drain height: 1.25 m
Min. drain height: 0.70 m
Safety valve inspection window
