WASHERUSE
Understanding Wash Cycles
When the washer lid is closed and Cycle Control knob is eat to a
number or cycle and pulled out, the washer fills (to the selected
load size) before agitation and timing start. Ifthe CATALYS'I"_
Cleaning Action is selected, the washer spins and sprays a
detergent solution for a brief period before filling with water. The
washer will not agitate or spin with the lid open.
During agitation, the agitator creates a continuous rollover action
that provides a thorough cleaning of the wash load.
After agitation starts, the Cycle Control knob turns clockwise until
it points to an OFF area and the cycle ends.
NOTE: The washer pauses briefly throughout each cycle. These
pauses are normal for washer operation.
WASH RINSE
r_ .spin-spray _ 1.Fill
(detergent
mixture)_
._ . Fill _ 2. Rinse
3.Wseh selected _ 3. Drain - No
time agitation
L_ . Drain - No r_l 4.Spin-Spray
agitation rinse
I_1 5.Spin I_1 5.Spin
tWhen the CATALYST" option
is selected, the washer spins
and sprays a detergent
solution for brief period prior
to filling.
L_ 6.Off
Lo=]
Loading suggestions
Forthese suggested full-sized loads, sat the LOAD SIZE selector
to the highest setting.
SUPER CAPACITY PLUS WASHERS
Heavy Work Clothes
3 pair pants 1 coverall
3 shirts 1 overall
4 pair jeans
Dellcates
3 camisoles 6 undergarments
1 quilted robe 2 sets of slsepwear
4 slips 1 child's outfit
Towels
1Obath towels 14 washcloths
10 hand towels 1 bath mat
MIxed Load
3 double sheets 2 shirts
4 pillowcases 2 blouses
8 T-shirts 8 handkerchiefs
6 pair shorts
Noma] Solmds
Your new washer may make sounds your old one didn't. Because
the sounds might be unfamiliar, you may be concerned about
them. These sounds are normal.
During washing
When you select a small load size setting, your washer has a
lower water level, This can cause a clicking sound from the upper
part of the agitator,
If you select CATALYS'ITM Cleaning Action, you will hear a spin/
spray noise at the start of the cycle,
During drain
If water is drained quickly from your washer (depending on your
installation), you may hear air being pulled through the pump
during the end of draining.
After drain and before spin
When the cycle changes from draining to spinning, you may hear
gears engaging.
