Daily Use
Load the laundry
Open the door by careful-
ly pulling the door handle
outwards. Place the laun-
dry in the drum, one item
at a time, shaking them
out as much as possible.
Close the door.
Make sure that no laun-
dry stays between the
seal and the door. There
is a risk of water leakage
or damage to the laun-
dry.
Measure out the detergent and the fabric softener
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent required, pour it into the
main wash compartment
or in the appropriate
compartment if the selected programme/option it re-
quires (see more details in "Detergent dispenser
drawer").
If required, pour fabric softener into the compartment
marked
(the amount used must not exceed the
«MAX» mark in the drawer). Close the drawer gently.
Select the required programme by means of the
programme selector dial (1)
Turn the programme selector dial to the required pro-
gramme.
The green pilot light of button 7 starts to flash. The se-
lector dial can be turned either clockwise or anticlock-
wise.
Turn the selector dial to position
to reset the pro-
gramme/to switch the machine OFF.
At the end of the programme the selector dial must
be turned to position
, to switch the machine off.
Important! If you turn the programme selector dial to
another programme when the machine is working, the
red pilot light of button 7 will blink 3 times and the
messageErr is displayed to indicate a wrong selection.
The machine will not perform the new selected
programme.
Select the spin speed by pressing button 2
When selecting a programme, the appliance proposes
automatically the maximum spin speed provided for that
programme. (See "Washing programmes" for the maxi-
mum allowed spin speed).
Press this button repeatedly to change the spin speed, if
you want your laundry to be spun at a different speed.
The relevant pilot light illuminates.
Select the available options by pressing the buttons
5 and 6
Depending on the programme, different options can be
combined. These must be selected after choosing the
desired programme and before starting the programme.
When these buttons are pressed, the corresponding pi-
lot lights illuminate. When they are pressed again, the
pilot lights go out. If an incorrect option is selected, the
integrated red pilot light of the button 7 flashes 3 times
and the message Err is displayed.
For the compatibility among the washing programmes
and the options see chapter «Washing programmes».
Start the programme by pressing button 7
To start the selected programme, press this button; the
corresponding green pilot light stops blinking.
The pilot light 9 illuminates to indicate that the appliance
starts operating and the door is locked.
If you have chosen a delayed start, the machine will be-
gin the countdown.
Important! If an incorrect option is selected, the
message Err is displayed for a few seconds and the red
pilot light of this button blinks 3 times.
Select the Delay Start by pressing button 8
Before you start the programme, if you wish to delay the
start, press this button to select the desired delay.
15
