If the malfunction or fault code reap-
pears contact your local Service Force
Centre.
For other fault codes not described in
the above chart, please contact your lo-
cal Service Force Centre.
Contact your local Service Force Centre,
quoting the model (Mod.), product num-
ber (PNC) and serial number (S.N.).
This information can be found on the rat-
ing plate located on the side of the
dishwasher door.
So that you always have these numbers
at hand, we recommend you to make a
note of them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The wash results are not satisfactory
The dishes are
not clean
• The wrong programme has been selected.
• The dishes are arranged in such a way as to stop water
reaching all parts of a surface. The baskets must not be
overloaded.
• The spray arms do not rotate freely due to incorrect ar-
rangement of the load.
• The filters in the base of the washing compartment are dirty
or incorrectly positioned.
• Too little or no detergent has been used.
• Where there are limescales deposits on the dishes; the salt
container is empty or incorrect level of the water softener
has been set.
• The drain hose connection is not correct.
• The salt container cap is not properly closed.
The dishes are
wet and dull
• Rinse aid was not used.
• The rinse aid dispenser is empty.
There are
streaks, milky
spots or a blu-
ish coating on
glasses and
dishes
• Decrease rinse aid dosage.
Water drops
have dried onto
glasses and
dishes
• Increase rinse aid dosage.
• The detergent may be the cause. Contact the detergent
manufacturer consumer care line.
30 electrolux what to do if...
