
After the checks are completed, activate
the appliance. The program continues
from the point of interruption.
If the problem occurs again, contact the
Service.
If the display shows other alarm codes,
contact the Service.
10.1 If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a
lower position.
• The quantity of detergent is too much.
Stains and dry water drops on
glasses and dishes
• The released quantity of rinse aid is not
sufficient. Adjust the rinse aid selector
to a higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The program is without a drying phase
or with a low temperature drying phase.
Leave the door ajar for some minutes
before you remove the dishes.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the multi-tablets can be
the cause. Try a different brand or acti-
vate the rinse aid dispenser and use
rinse aid together with multi-tablets.
Refer to “HINTS AND TIPS” for
other possible causes.
10.2 How to activate the rinse
aid dispenser
The activation of the rinse aid dispenser
can occur only with the Multitab option
activated.
1.
Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode, refer to “Set-
ting and starting a program”.
2.
Press and hold, at the same time, De-
lay and EnergySaver until the indica-
tors
, and
start to flash.
3. Press TimeSaver,
•
The indicators
and go
off.
•
The indicator
continues
to flash.
• The display shows the current set-
ting.
Rinse aid dispenser off
Rinse aid dispenser on
4. Press TimeSaver to change the set-
ting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
6. Adjust the released quantity of rinse
aid.
7. Fill the rinse aid dispenser.
11. TECHNICAL INFORMATION
Dimensions Width / Height / Depth (mm) 596 / 850 / 610
Electrical connection Refer to the rating plate.
Voltage 220-240 V
Frequency 50 Hz
Water supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )
ENGLISH 17