
It is important for the dishwasher to be ab-
solutely horizontal so that the door seals
properly. The adjustable feet are to be turned
to the left or right until the dishwasher is hor-
izontal. If there is a space at the bottom of the
machine, this can be covered by lowering the
plinth.
Fitting the steam protection
Screw the steam protecting onto the front
part of the worktop using the supplied
screws.
Fixing to the adjacent units
Secure the dishwasher by screwing it firmly
in position under the bench or to the cup-
board beside it. Use the angular brackets
supplied which are fitted into the slots on the
top of the dishwasher (see fig.). Tighten the
machine in position (upwards or sideways)
by using the screws supplied (3.5 x 16 mm).
Tighten the screws so that the dishwasher
cannot tip forward and cause damage when
the door is open and loaded. The dishwasher
must be secured to the underside of the
worktop or to adjacent units by using the
brackets supplied. Neglect to do this can
cause injury or damage. Under no circum-
stances may holes be drilled through the
sides of the dishwasher since this could
damage the hydraulic components.
The dishwasher must be secured to the
underside of the worktop or to adjacent
units by using the brackets supplied.
Neglect to do this can cause injury or
damage. Under no circumstances may
holes be drilled through the sides of the
dishwasher since this could damage the
hydraulic components.
Water supply connections
This dishwasher may be fed with either hot
(max. 60°) or cold water. Nevertheless we
advise you a cold water supply. A hot water
supply is not always efficient with very soiled
crockery as it shortens the washing pro-
grammes a lot.
For making the connection itself, the cou-
pling nut fitted to the machine’s supply hose
is designed to screw onto a 3/4" gas thread
spout or to a purpose made quick-coupling
tap such as the Press-block.
electrolux 19