
Upper basket
cup racks: position A
Installation
Any electrical and/or plumbing work
required to install this appliance should
be carried out by a qualified electrician
and/or plumber or competent person.
Remove all packaging before positioning the
machine.
If possible, position the machine next to a
water tap and a drain.
Building-in
This dishwasher is designed to be fitted un-
der a kitchen counter or work surface.
It is essential that the recess dimensions in-
dicated in the illustration are followed.
The height of the recess where the dish-
washer is to be installed can vary between
820 and 880 mm from the floor since the
dishwasher is fitted with adjustable feet (max.
60 mm).
No further openings for the venting of the
dishwasher are required, but only to let the
water fill and drain hose and power supply
cable pass through.
Leave a space of 2 mm between the top of
the dishwasher and the underside of the
kitchen counter.
During all operations that involve accessibility
to internal components the dishwasher has
to be unplugged.
When inserting the machine, ensure that the
water inlet hose, the drain hose and the sup-
ply cable are not kinked or squashed.
Adjusting the height of the dishwasher
To adjust the height proceed as follows:
1. Loosen or tighten the two front feet.
2. Loosen and remove the adjustable plinth.
3. Adjust the rear foot by turning the screw
in the middle of the front kick plate to the
left or to the right. Good levelling is es-
sential for correct closure and sealing of
the door.
When the appliance is correctly levelled,
the door will not catch on the levelling
spacers on either side of the cabinet. If
the door does not close properly, loosen
or tighten the adjustable feet until the
machine is perfectly level.
Adjusting the height of the plinth
18 electrolux