Connect Systems Inc. - Model 9800 Page 30
Return to A.A. by hitting 0* you will then hear Morse code AA (dit-
dah dit-dah) after you let go of the PTT button.
At this point you could either branch to a new programming line to
make additional programming changes, or...
Exit remote programming mode by holding down the * for more than one
second. The 9800 will respond with the Morse K (dah-dit-dah) and
then return to the operate mode.
Example of programming from a telephone:
Before you begin two points must be made:
1. Remember, when Remote Programming over the air, the access code
is preceded with a four second #. When Remote Programming from a
telephone a four second * is used if the 9800 is set for remote
base operation, otherwise use a four second #. If in doubt first
try #, if no luck try *.
2. If line 3.8. has been set to 0 (no auto-answer) and line 5.4.
is set to a 1 (Remote Programming enabled), then a default auto-
answer will occur on ring number 11. If line 3.8. is not set to
0, then it must be set to a larger number than 3.4. has been
set. Auto-answer will occur on the ring number you have set on
line 3.8.
You wish to change the access code for the interconnect to *825 (set
on line 1.4. in Programming Area No.1)...
Call the phone number of the line the 9800 is connected to. Upon
auto-answer, enter the * or # for four seconds followed by 23451
(access code appended with a 1 to enter Programming Area No. 1).
Transponds will be beep responses.
The 9800 will respond with AA in Morse (dit-dah dit-dah). Now hit
14* to select line 1.4. Then enter 825#.
If you hear a single beep in response, you have entered new data.
You may now verify your entry by entering 825# a second time. If the
current entry matches the previous entry, a double beep will be
heard.
Return to A.A. by hitting 0*, you will then hear Morse code AA (dit-
dah dit-dah) which lets you know you are at A.A. You may now
program other lines, or...
Exit remote programming mode by holding down the * for more than one
second. The 9800 will respond with the Morse K (dah-dit-dah) and
then return to the operate mode. Hang up the phone as soon as you
hear the 9800 disconnect.
Note: If there is no DTMF programming activity for 25 seconds, the
9800 will automatically return to the operate mode.
