Connect Systems Inc. - Model 9800 Page 11
PROGRAMMING THE OPERATING MODE AND PARAMETERS
(Programming Area No. 1)
To enter the parameter programming mode, press and hold button No. 1
on the internal keypad and then simultaneously turn on the power
switch. At this point, the display will read 0.1. When you release the
No. 1 button, you will see A.A.
A.A. (GOTO Any Address)
Press 'P' to start at line 0.1., or enter the line number
you wish to go to and then press 'P'. All line numbers and their
associated parameters are listed below starting with OPERATING
MODE SELECTION.
Viewing or Changing Parameter Values
A quick tap on 'C' will reveal (for a moment) the currently
selected parameter of the displayed program line. If the
parameter is acceptable, press 'P' to advance to the next
program line, or, enter a new parameter and press 'P' to
advance to the next program line.
Parameter Checking
If an out of range parameter is entered (e.g. 87 on line
0.2.) pressing 'P' will not cause an advance to the next
program line. This prevents you from accidentally entering
an unusable choice.
Returning to A.A.
Programming is finished when you arrive back at A.A. If
necessary, you can return to a previously programmed line by
holding down 'C' for several seconds. This will return you
to A.A. Now enter the line number you wish to return to and
press 'P'. Line sequential programming will always flow
forward from the current line.
Line numbers shown in braces e.g. [1.4.], indicate where
programming will continue after a selection.
When you finish programming, simply turn the power off, and then
back on to return to the operate mode.
OPERATING MODE SELECTION [Branch to]
0.1. Operating Mode
0 = Sampling Simplex [0.2.]
1 = VOX Simplex [0.5.]
2 = Duplex / Repeater Controller [0.8.]
DEFAULT: 1 = VOX Simplex
Note: The FM detector connection method is required for the
Sampling Simplex mode! (A COS connection would be too slow)
