MAINTENANCE AND CLEANING
Unplug the appliance before commencing any kind of maintenance.
• To clean the inside of the appliance and accessories we suggest you use a water and
vinegar solution; never use abrasives, detergents or soap.
• The shelves are attached to the sides of the doorframe.
• Clean periodically the water drain hole, located on the rear wall with a ramrod or a blunt
stick.
• Clean the door gasket with water and dry carefully.
• What to do when the appliance is idle: If the appliance must be idle for a long period of
time, unplug and empty it, clean the inside and leave the door open (to prevent bad
odors).
BUILDING-IN INSTRUCTIONS
Fitting the appliance into the enclosing cabinet: Fig. 1-Fig 2a-Fig 2b.
• Check that the dimensions of the enclosing cabinet and appliance are compatible.
• If necessary, mount plastic beam B on the upper frame C made of sheet steel.
• Position the appliance by aligning the upper frame C (or the plastic beam B) with the
corner of the enclosing cabinet. Shorten strip D to height of the notch and mount it with
its adhesive side glued to the wall of the appliance.
• Push the appliance against the cabinet wall to press in strip D and tighten the top and
bottom fastening screws.
• Mount the brackets for runner E on the outside of the appliance door (using the existing
holes) and with the doors fully open, fit the door runner F on the cabinet door. - Adjust
the coupling between the appliance door and cabinet door and cover the runner screws
with special adhesive caps.
