TECHNICAL SUPPORT
Irregular operation is not always caused by a defect in the appliance, but rather by bad
installation or misuse. To avoid unnecessary maintenance jobs and expenses incurred by
calling technical support, we suggest you follow the guidelines below : -
The internal temperature is not cold enough.
Check: -
The door closes perfectly.
The thermostat is correctly positioned.
The refrigerator is not near any heat sources.
The refrigerator is not leaning against the walls and air circulates freely.
There is no excess hoarfrost in the deep-freeze compartment.
The internal temperature is too cold
Check: -
The thermostat is turned to the correcting setting.
The appliance is too noisy.
Check: -
The appliance is properly leveled.
The rear coil does not touch the back wall.
The appliance does not work at all.
Check: -
The thermostat is not set to 0.
Power supply is not disconnected.
The plug has a firm contact in the wall socket.
The power cable is not broken (see “Caution” paragraph).
Some water seeps out of the refrigerator.
Check: -
The drainage circuit.
The compressor evaporation tub is full of residues and must be cleaned.
If normal operation cannot be achieved after completing the above checks, contact your
nearest service centre. Please see back page for details.
The manufacturer shall not be held responsible for any damages that may,
directly or indirectly, be caused by persons, pets or things, resulting from the
failure to comply with all the guidelines given in the instruction handbook. These
especially concern precautions to be taken during installation, operation and
maintenance. The manufacturer also reserves the right to make any changes that
may be deemed appropriate for technical refinement or commercial development
at any time and without having to give prior notice.
