2
Preparation
This section provides instructions on how to change the KWS600v3’s factory IP address setting and
upgrading the firmware.
Connecting a Computer to the KWS600v3
The KWS600v3 communicates through a standard LAN cable.
1. Connect the LAN cable to the computer or LAN switch.
2. Connect the LAN cable to the ETH1 port of the KWS600v3.
PC Network Settings
The KWS600v3 is configured by default with a static IP address of 192.168.1.1. In the event that this IP
address conflicts with other IP addresses in your local network, or that this IP address is not in the same
subnet as your network, then you must change the KWS600v3’s IP address. To access the KWS600v3
and change its IP address, you must first change your PC’s IP address to be on the same subnet.
NOTE: Take note of your original network settings before making any changes, because you must
change these settings back after changing the network configuration on the KWS600v3.
To change the IP address of your computer for Windows® Server 2008/Windows Vista:
1. Select Start > Control Panel.
2. If you have the classic view, double-click Network and Sharing Center and then select Manage
Network Connections. If you have the category view, double-click Network and Internet >
View network status and tasks and then Manage Network Connections.
3. Double-click the active LAN or Internet connection.
4. Select Properties.
5. In the Networking tab, highlight the Internet Protocol (TCP/IP) item, and select Properties.
6. In the General tab, select Use the following IP address and enter:
IP address: 192.168.1.2
Subnet mask: 255.255.255.0
7. Select OK.
