2-8
Chapter 2
Programming Procedures
SPECIAL APPLICATIONS
This part of the manual is titled “Special Applications” because it provides information about interfacing
with customer–provided equipment (CPE) or using a feature in a different way than it was intended. Perhaps
an application may require a combination of CPE, creative programming, unusual feature operation or all of
the above.
Because these applications require installation instructions and a combination of programming sequences,
there is no obvious place to put this information; therefore, it is placed here. As additional special
applications are reported from the field, they will be included in this section.
802: CUSTOMER ACCESS MMC NUMBER SEE MMC 802
804: SYSTEM I/O PARAMETER SEE MMC 804
805: TX LEVEL AND GAIN SEE MMC 805
806: CARD PRE
–
INSTALL None
807: VOLUME CONTROL SEE MMC 807
809: SYSTEM MMC LANGUAGE ENGLISH
810: HALT PROCESSING None
811: RESET SYSTEM None
812: COUNTRY CODE None
Technical Manuals Online! - http://www.tech-man.com
