21
Setup Guide
6. Type a name for the port in the
Name box. Make sure the
name is not the same as an existing port, such as LPT1.
7. Select the target node address from the
Card Address list.
Make sure this address matches the one listed under Node
Number on the status sheet.
8. Click the
Timers
button and select the
Job Based
option.
Then click
Close.
9. Click
Next, then follow the instructions on the screen for
printer driver installation.
Configuring the Ethernet Card in Windows
NT 3.5x
After you have installed the DLC protocol, follow these steps to
configure the card and your printer for Windows NT 3.5x:
1. Double-click Print Manager
in the Main group.
2. Choose
Create Printer from the Printer menu. The Create
Printer dialog box appears.
3. Type a name for the printer. Then select the printer driver
from the Driver menu. Select
Other from the Print To
menu. The Print Destinations dialog box appears.
4. Choose Hewlett Packard Network Port
from the
Available Print Destinations list.
5. Type a name for the port in the Name box. Make sure the
name is not the same as an existing port, such as LPT1.
6. Select
LAN Hardware Address (Node Address) from
the Card Address list. This address matches the one listed
under Node Number on the status sheet.
7. Click the
Timer button and select the Job Oriented
option. Then click
OK. Click OK again to exit the dialog
box.
Note:
If you want to share the
new printer, click Share
the Printer on the
Network. The share
name defaults to the
printer name; you can
change it if necessary.
For more information
about sharing, see your
Windows NT
documentation.
QuikSet2.fm Page 21 Wednesday, October 15, 1997 3:49 PM
