Page | 218
Figure 203: Completed assembly
17.8.3) Stack dash speed sensor fitment
Route the speed sensor loom through the
hole on the tunnel top along with main
wiring loom to the front of the chassis near
LHS wheel. Use cable ties to route the
loom where necessary. Connect the
speed sensor plug to the plug on main
wiring marked as wheel sensor refer
figure 205.
Figure 204: Wheel speed sensor plug
1. Plug on the wheel speed sensor loom
2. Plug on the main wiring loom
Insert the speed sensor in to the bracket
and secure with locknut (do not tighten).
Refer figure 206. Remove 2 caphead bolts
on the LHS brake calliper and fit the
bracket with speed sensor to the calliper
(do not tighten). There are four bolts on
the brake disc, speed sensor should be
adjusted by aligning with one of the four
bolts. Select any of those bolt by rotating
the disc and Adjust the speed sensor front
edge so that the gap between the sensor
and the bolt on the disk is 2-3 mm. tighten
the lock nut on the sensor. Tighten the
bolt on the calliper (50NM) and secured
the bracket in place. Refer figure 207.
Figure 205: Wheel speed sensor
bracket
