9
Headlight main beam – BLUE
Illuminates when the headlights are switched to main
beam.
Immobiliser Warning light - Red
See section on Immobilisation.
Stack Display System
The Stack display system combines an analogue
tachometer with a digital display for the following
performance parameters:
1. Vehicle speed
2. Engine speed
3. Oil pressure
4. Oil temperature
5. Water temperature
6. Fuel level
7. Battery Voltage
8. Lap times (optional) available from aftersales.
An alarm light alerts the driver that a warning condition
has been detected. The warning conditions are based
on pre-set alarm values for the above listed
performance parameters 3-7. When the alarm light is
on, a warning message is shown on the digital display
to identify the condition. It is possible to enable or
disable the warning system for each parameter
individually. The warning message can be cancelled by
pressing any switch. Doing this does not turn off the
warning condition alarm light, which stays on until the
condition no longer applies.
The digital display has five screen display options each
showing certain parameters and their values. The
different screen can be changed by pressing button 3.
Screen 1
Fuel level
Current speed
Trip indicator
Odometer
Press button 3 to change to screen 2
Screen 2
Oil temperature
Current speed
Oil pressure
Press button 3 to change to screen 3
Screen 3
Water temperature
Current speed
Oil pressure
Press button 3 to change to screen 4.
Screen 4
Current speed
Battery Voltage
Ambient air temperature is shown but not utilised
in the set-up. This will default to a reading of -999
Press button 3 to change the display to screen 5
Screen 5
Number of current lap
Current speed (mph or km/h)
Last lap time
Previous best lap time
Press button 3 to change the display back to screen 1.
NOTE: The minimum oil and water temperature for
which the display gives a true reading is 12°C or 53°F.
The unit displays temperatures that are less than this
as 0°C or 32°F.
Peak values (Tell Tales)
The system records Max (or Min where appropriate)
values for each parameter, when the engine is running
at more than 1200 rpm.
This is to prevent abnormal peak values from being
recorded when, for example, the engine is either not
running, is idling, or is being warmed up.
Displaying the Peak Values
Press and hold button 1 to show the peak values for
the parameters currently being displayed. Release the
switch to return to the normal display.
Resetting Peak Values
The peak values remain stored until reset. To reset,
press and hold button 1 and then press button 4 as
well. This clears all the peak values & lap times.
Alarms
The display system has built-in warnings to alert the
driver when certain parameters either exceed or fall
below their alarm values.
Displaying an Alarm
When an alarm condition occurs, the built in red
warning light turns on, and the digital display gives a
warning message to show the type of alarm.
NOTE: The amber light indicates low fuel warning.
Clearing an Alarm
Press button 2.
Showing the Last Alarm
Press and hold button 2.
