36
CALL TYPES AUDIOLINE FF895-2
INTERCOM CALL
It is possible to call between a handset and the base unit using the intercom function (this
is a free call). When there is more than one handset registered you can call each handset
from the base unit. (It is not possible to call between handsets). To use the intercom,
do the following:
# Press the [INTERCOM] button on either the base or handset. The unit starts to ring,
and “paging” will flash on the handset display.
# Answer the call by pressing the [INTERCOM] button.
# Press [INTERCOM] button again to finish the call.
TRANSFERRING CALLS
An external call can be transferred from one handset to the base unit or another handset
(the handsets must be registered to the same base unit and within operating range of the
base). Calls can also be transferred from the base unit to any registered handset.
HANDSET
## After answering an external call, press and hold the [INTERCOM] button until "Trans
to HS" appears in the display. This will put the caller on hold temporarily.
# Enter the identity number of the handset to which the call is to be transferred. 0 - 4,
where 0 is the number of the base unit/speakerphone.
# The call is now transferred and the handset returns to stand-by.
BASE UNIT
# After answering an external call, press and hold the [INTERCOM] button until “Tr”
appears in the display.
# Enter the identity of the handset to which the call is to be transferred (1- 4).
# The call is now transferred and the base unit returns to stand-by.
NOTE: If the handsets or base unit to which the call has been transferred, do not
take the call, it will transfer back to its point of origin. At this time, if the call is not
picked up, it will be disconnected after 20 seconds.
