Mount the front bunk support weldments to the pivot weldments by
placing them in the channel of the pivot weldments and attaching with
1/2” x 4-1/2” hex bolts and lock nuts. Place the bunk assembly over the
support weldment, align the holes of the bunk brackets with the holes in
the support weldment and secure using 1/2” x 1-1/2” carriage bolts and
lock nuts. Tighten but do not over tighten because the bunks must rotate
to conform to the boat bottom.
Note: The bunk pivot base weldment is adjustable on the front cross.
Loosen the 1/2” U-bolts (Ref#3, Page 14) enough to move the bunk pivot
base weldment in or out on the front cross to a location that best
conforms to your watercraft.
Front Bunk Assembly:
Midwest Industries, Inc. Ida Grove, IA 51445 (800)859-3028 www.shorelandr.com M303186
Page 11
Front Bunk Assembly
