Mount the rear bunk support weldments to the pivot weldments by placing
them in the channel of the pivot weldments and attaching with 1/2” x 4-1/2”
hex bolts and lock nuts. Place the bunk assembly over the support
weldment, align the holes of the bunk brackets with the holes in the
support weldment and secure using 1/2” x 1 1/2” carriage bolts and lock
nuts. Tighten but do not over tighten because the bunks must rotate to
conform to the boat bottom.
Note: The bunk pivot base weldment is adjustable on the front cross. Loosen
the 1/2” U-bolts (Ref#3, Page 14) enough to move the bunk pivot base
weldment in or out on the front cross to a location that best
conforms to your watercraft.
Rear Bunk Assembly:
Midwest Industries, Inc. Ida Grove, IA 51445 (800)859-3028 www.shorelandr.com M303186
Page 10
Rear Bunk Assembly
