ELECTRICAL SySTEMS
H - 17
H
monitor. The camera turns on automatically when in reverse or can be turned
on manually with the switch on the mirror/monitor to view in transit. Please
disregard the Bluetooth Connected/Disconnected pop up message when the
monitor turns on and the Bluetooth No Connection message whenever the
monitor moves out of standby mode. They will go off after about 15 seconds.
See monitor owner manual included in your Owner’s Packet for operation and
Bluetooth hook up information.
Auxiliary Fuse Locations
In addition to the 12-volt fuses and breakers described in the this section,
some components have additional fuse protection as supplied or required by
their manufacturer.
Locations:
LP detector: 1.2 amp fuse behind detector.1.
Battery Separator power line to engine battery: 125 amp inline fuse inside 2.
Sprinter battery compartment under driver’s floorboard.
Monitor panel battery voltage display: Sprinter battery compartment on 3.
fuse power distribution bar under driver’s seat. (5 amp)
Inverter: 125 amp inline fuse under rear lounge or roadside bed by in-4.
verter/charger.
Dash radio: 10 amp fuse on back of radio.5.
Rear view camera (option): 1.5 watt inline fuse behind antenna booster.6.
Thermostat display: Fused to 5 amp breaker on front of furnace.7.
Monitor Panel
TouchSensor Technologies, LLC
Phone: 630.221.9000
http://www.touchsensor.com
The monitor display panel shows the fluid levels of the Black, Grey, and
Fresh water tanks, and the Liquid Propane gas tank. Push the Tank Test
rocker switch to tank fluid show levels in 1/3 increments.
The panel also shows the voltage status of the Main (engine) and the
Auxiliary (house) battery by using a labeled rocker switch.
BATTERY VOL TAGE
TANK TEST
BATT MAIN
BATT
AUX
F
F
F
2/32/3
2/3
1/3
1/31/3
EE
E
BLACKGREY FRESH
LPG
touchsensor
