Chapter 2 System Startup 19
5: Press the touchscreen where the 2nd radial button appears.
6: Close the calibration program. The calibration is complete.
2.8 First System Boot
After you have properly installed the CompactFlash™ memory card
pre-installed with Windows CE
®
or with specific application software,
all you have to do is simply plug in the power and the system is ready
for the first boot.
Please follow the steps below to perform your first system boot:
1.Turn on the power switch. Meanwhile, the power LED on the front
panel will light up.
2.The Windows CE
®
operating system starts to boot from the Compact
Flash™ memory.
3.Wait for a while for Windows CE
®
to complete its first startup.
After you have successfully booted for the first time, you can now
assign a device name to your TPC-650 for network identification.
1. First click on Start/Settings/Control Panel/Communication Proper
ties to access the Communication Properties page.
2.Select the Device Name tab on the properties page, and assign a
device name to your TPC-650. The Device Name is what comes to
distinguish your TPC-650 within the network environment.
3.Click on OK to accept the Device Name setting.
4. Click on Start/Run.
5.When the dialogue box pops up, key in "regsave" command in the
text box and click OK.
6.Reboot your system to make your Device Name effective on the
network.
After you have assigned a Device Name to your TPC-650 on the
network, you can proceed further with other configurations or installa-
tion procedures.
