Chapter 2 System Startup 17
To connect the power adapter:
1.Identify each wire of the power adapter cord (you must first make
sure which is +, - or GND specifically).
2.Unscrew the screws on the power terminal. insert each wire of the
power adapter cord specifically into its designated connector hole
(+, - and GND) on the power terminal block. Fasten the screws to
secure wires in the connector holes.
Note: The power terminal block is in the accessory pack
shipped together with the TPC-650. However, the
24V
DC
power adapter is an optional item to TPC-650.
You can purchase it from Advantech separately, or
find it from another vendor.
Warning: Avoiding shorting any bare wires since it may cause
damages to your system or device.
Figure 2-9: Connecting the power adapter
