3
ENGLISH
B
2
3
1
AC
B
D
A
Check
Action
Check Settings Screen is Displayed
The screen appears when an IP address was not
obtained automatically due to incorrect network key or
inactive DHCP function.
It may also appear when using the MAC address
ltering feature or the rewall function.
If the network key is incorrect, enter the network key
again and click Connect (A).
Check 1
Make sure that the DHCP function of the access point is active.
For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
•
If the DHCP function is inactive, enable the DHCP function of the access point or
specify the IP address of the machine, then click Connect (A).
For details on how to change the settings of the access point, refer to the manual supplied with
the access point or contact its manufacturer.
•
To specify the IP address of the machine, click Set IP Address (B), then follow the procedure in
Check 4 of "Set Printer IP Address Screen is Displayed" on page 4.
•
Check 2
For details on how to check the network key of the access point, refer to the manual supplied with
the access point or contact its manufacturer.
•
Check Access Point to Be Used Screen is Displayed
To use roaming, select Use multiple access points (D), then click OK or Continue
(C).
When you have only one access point
The access point selected in the Detected Access
Points List screen will be used. Make sure that the
target access point is selected correctly by following
the procedure below, then proceed with the setup.
When using multiple access points (roaming)
Glossary
A unique number assigned to each network device.
MAC address•
A function to provide seamless communication when multiple access points with the same SSID are in
use by automatically connecting to another nearby access point upon interruption of signals from the
current one.
Roaming•
Select the access point name/network name (SSID) that matches the MAC
address of the target access point, then click Connect.
Select Use one access point (B), then click OK or Continue (C).
Click Cancel or Back (A).
Detected Access Points List screen returns.•
The Check Access Point to Be Used screen is displayed.•
For details on how to check the MAC address of the access point, refer to the manual
supplied with the access point or contact its manufacturer.
•
The message appears when multiple access points
with the same name are found.
An identier to identify the specic access point. Also called an access point name or a network name.
SSID•
Is the MAC address ltering enabled on the access point?
For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
•
Check 3
