9
ENGLISH
6-A
5
4
2
3
1
F
J
H
I
G
K
6-B
7
1
2
M
L
N
When WEP 40 bit is selected in AirPort Utility (AirPort Admin Utility), select 64 bit.•
When WEP (Transitional Security Network) is selected in AirPort Utility, select 128
bit.
•
WEP
Select Authentication (J), then click OK (K).
Go to
.
Select Key ID (I).
Enter upper and lower case letters of the alphabet correctly when the network key is
5 or 13 characters. Letters are case sensitive.
Letters are not case sensitive if the network key is 10 or 26 characters (digits).
•
Select Key Length (G).
Select ASCII when the network key is 5 or 13 characters.
Select Hex when it is 10 or 26 characters (digits).
•
Select Key Format (H).
When using AirPort, select 1 in the screen.
Selecting other key numbers will disable the connection between the machine and
AirPort.
•
Enter the network key in WEP Key (F).
WPA/WPA2
Disable
When WEP (Transitional Security Network) is selected in AirPort Utility, select
AES(Secure Encryption).
•
Disable
WPA/WPA2
Enter the network key in Passphrase (L).
Enter upper and lower case letters of the alphabet correctly when the network key is
between 8 and 63 characters. Letters are case sensitive.
Letters are not case sensitive if the network key is 64 characters.
•
Select Dynamic Encryption Type (M), then click OK (N).
The Manual Setup screen returns. Click Connect.
After that, follow the on-screen instructions to proceed with settings.•
Go to
.
When the access point is set to operate in IEEE802.11g and IEEE802.11n with TKIP,
communication is established using IEEE802.11g.
•
When the access point is set to operate only in IEEE802.11n with TKIP, a connection
cannot be established. Change the encryption type to something other than TKIP or
change the standard to something other than IEEE802.11n, then congure wireless
LAN settings again.
•
