15
Starting a programme
1. Check that the tap is turned on.
2. Press the
button (START/PAUSE). The programme is started or it
starts after the time delay set has elapsed.
3 If after pressing the button (START/PAUSE) E40 flashes in the
multi-display, the (END) indicator flashes 4x and at the same time an
acoustic signal sounds 4x, the door has not been correctly shut. Push
the door firmly closed and press the
button (START/PAUSE) again.
Programme progress
• The programme progress display shows the programme step that is
currently being carried out.
– (Prewash)
– (Main wash)
– (Rinse)
– (Extra Rinse)
– (Spin)
– (End)
• The multi-display shows the estimated time remaining (in hours and
minutes) until the end of the programme.
3 The remaining programme time may increase or briefly remain constant
during the wash programme as the programme adjusts to various con-
ditions while washing (e. g. type of washing, amount of washing, rec-
ognising out-of-balance when spinning, special rinse cycle, etc.).
Interrupting a programme/Adding washing
Interrupting a programme
• A washing programme can be interrupted at any time by pressing the
button (START/PAUSE) and then re-started by pressing the
button (START/PAUSE) again.
• To stop the washing machine before the programme has ended, turn
the programme knob to (OFF). Important: Be careful if there is
water in the appliance!
Adding washing
It is possible to add washing, as long as the (DOOR) light is lit green.
1. Press the
button (START/PAUSE). The door can be opened.
2. Close the door and press the
button (START/PAUSE) again. The
programme will continue.
