Do not place the inlet hose downwards. Angle
the hose to the left or right depending on the
position of your water tap.
3. Set the hose correctly by loosening the ring nut.
After positioning the inlet hose, be sure to tighten
the ring nut again to prevent leaks.
4. Connect the hose to a tap with a 3/4” thread.
Always use the hose supplied with the appliance.
The inlet hose must not be lengthened. If it is too short and you do not wish
to move the tap, you will have to purchase a new, longer hose specially
designed for this type of use.
Water-stop device
The inlet hose is provided with a water stop device,
which protects against damage caused by water leaks
in the hose which could develop due to natural ageing
of the hose. This fault is shown by a red sector in the
window «A». Should this occur, turn the water tap off
and refer to your Service Centre to replace the hose.
Water drainage
This appliance is designed to be permanently
plumbed into your home's drainage system using one
of the following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain hose using
the «U» piece” supplied.
Place the drain hose into your
standpipe, which should have an
internal diameter of approximately
38mm thus ensuring there is an air
break between the drain hose and
standpipe.
47
Installation
P1199
U piece
supplied
P1074
30 cm (12")
38 mm (11.2)
standpipe
diameter
132969171.qxd 31/01/2008 12.18 Pagina 47
