diode. An
OL
reading indicates an open diode.
In either case, the diode is defective and
should be replaced.
CHECKING FOR CONTINUITY
(1) Turn the function switch to the (DAMP60)
or (DAMP68) position. Press the
SHIFT
button to select continuity checking mode.
(2) Plug the black and red test leads into the
– and + input terminals, respectively.
(3) Touch the test leads to any two points of a
circuit. If the resistance between those points
is ⭐30⍀, the beeper will sound continuously.
MEASURING TEMPERATURE
(DAMP68 ONLY)
Warning
To avoid possible damage to the meter or
other equipment, remember that the included
“K” Type thermocouple is rated -40° to 752°F
(-40° to 400°C).
When the meter is not connected to the included
thermocouple,
OL
will be shown on the display.
(1) Turn the function switch to the
°C/°F
position.
°C
is the default setting. Press the SHIFT
button to select
°F
.
(2) Plug the included “K” type thermocouple into
the meter's – and + terminals, making sure to
insert the pin marked + into the + terminal.
(3) Read the measured temperature on the
display.
16
