Wintech Brand's Products

2 of 6

Foot Bracket Removal and Replacement

Requires the following:

1. Tiltunituponthemuferend(Fig.3).Raisegeneratorhighenoughtoallowforinstallationofwheelassembly.

2. Remove existing front and rear foot brackets with 12mm socket. Keep hardware (A) for steps 3 and 4.

3. Install new front foot bracket on control panel end of generator (Fig. 4). Use 12mm socket to reinstall hardware.

4. Installwheelbracketassemblyonmuferendofgeneratorasshown(Fig.5).Use12mmsockettoreinstall

hardware.

5. Return generator to original position.

Quantity Part description Part number Tool required

1 Wheel assembly Multiple 12mm socket

1 Front bracket Multiple 12mm socket

Control Panel End

MuferEnd

Fig. 5, Wheel Assembly Detail

Fig. 4, Front Foot Bracket Detail

(Handle not shown)

Fig. 6, Completed Bracket Installation

Fig. 3, Removal of Existing Brackets