9
4.1 Installation and inter-connection
Naawigo Mini N is equipped with safety features for the protection against direct and
indirect contact. However, the installation must be carried out by appropriately
qualified personnel who must observe the following precautions:
• check the package and promptly notify the supplier in case of damage,
• make sure access points, antennas and support structures are properly installed to
avoid health hazards,
• make sure that installation of the access point, antennas and cables is made in
accordance with local regulations regarding safety.
4.2 Preparing and switching on the device
To use the device plug in the power supply to the mains and insert the 220/230V plug
into the socket of the device.
The device starts up and after about 60 seconds it reaches a fully functional status.
If you are using the optional passive PoE switch: plug in the power supply to the mains
and insert the 220/230V plug into the DC jack of the PoE switch and connect a CAT5
UTP cable to the “OUT” port of the switch and to the RJ-45 port of the device.
To fix the device to a wall you can use the jig you can find in the package.
4. SETTING UP OF THE DEVICE
