Vopbx Brand's Products

POW4060 EN

8 OPERATING INSTRUCTIONS

Do not sand plaster surfaces, (WARNING: In this case your guarantee

becomes void) this may clog the motor (brushes, ball bearings,…).

8.1 Switching On-off

Press On-off switch I/O

8.2 Speed adjusting dial

 The tool speed can be infinitely adjusted between 4000min

-1

and 14000 min

-1

Higher

speed is obtained when the dial is turned in the direction of 6; lower speed is obtained

when it is turned in the direction of 1

9 WORKING WITH THE ROTATING SANDER

 The entire sanding surface must rest on the workplace.

 Switch on the machine and. apply moderate pressure, move it over the workpiece in

circular. Crosswise or lengthwise movements.

 Use a coarse-grained disk for rough sanding and a fine-grained disk lot line sanding. The

best grain for a particular job is best ascertained by trial runs.

Important! Wear a dust mask and goggles

Protective gloves are recommended.

The sender must never be used for work on materials which contain

asbestos.

10 TECHNICAL DATA

Power rating

480W

Mains voltage

230V

Mains frequency

50Hz

Sanding Ø

125mm

No load speed

4000-14000min

-1

Safety class

11 NOISE

Noise emission values measured according to relevant standard. (K=3)

Acoustic pressure level LpA

79 dB(A)

Acoustic power level LwA

90 dB(A)

ATTENTION! Wear hearing protection when sound pressure is over 85

dB(A).

aw (Vibration)

3.52 m/s²

K = 1.5 m/s²