Page 9 of 9
Premium Tech Tool
Information is subject to change at any time without notice. Any printed copy of this bulletin is an uncontrolled document.
I am getting an error on the SRS product data Hardware and Software.
This is most likely caused by an error with the Lane Departure Warning System.
Remove the fuse for the LDWS, restart the PC and try again.
Where can I find the saved information from the tests and
programming that
have been performed with Tech Tool 2?
Under the Product History tab.
Note: There may be more than one session file for each vehicle.
Is parameter programming with templates supported by Tech Tool 2?
Not at this time. This should be available at a later date.
Can I save the parameters from a vehicle in Tech Tool 2?
This should be available in the near future. To print this data, go to the top left
of
the page and click on the “Tech Tool” dropdown and select Print. This does
a print
screen type document.
Can I print the parameters from a vehicle in Tech Tool 2?
There is a print screen function that is working now. Improvements are being
developed. The improvements should be available in December 2013.
Where is the EGR valve test?
This test is in Function Group 29. Both in Impact and in Tech Tool.
Function
Group 25 was too full, so the EGR was put in FG 29.
Where is the “Learned Data Reset” for the OBD2013 vehicles?
This test is found under the Calibration tab Function Group 1 Function
Monitoring Parameters.
