EVAPORATOR INSTALLATION
ON A WORK BENCH, INSTALL EVAPORATOR REAR BRACKET AND HARDLINES WITH PROPERLY LUBRICATED O-RINGS.
(SEE FIGURE 10, PAGE 11, AND FIGURE 15, PAGE 16.)
REMOVE 2 OEM HEATER PLUGS IN FIREWALL, SEE FIGURE 7 PAGE 9.
INSTALL FRONT MOUNTING BRACKET ON EVAPORATOR USING (2) 1/4-20 X 1/2 HEX BOLTS AND TIGHTEN AS
SHOWN IN FIGURE 5 BELOW.
LIFT EVAPORATOR UNIT UP UNDER THE DASHBOARD SEE FIGURE 6. SECURE LOOSELY TO THE FIREWALL FROM THE
ENGINE COMPARTMENT SIDE USING (2) 1/4-20 NUT AND WASHER, SEE FIGURE 6 BELOW.
USING (2) #14 X 3/4 SHEET METAL SCREW w/ 1/4 FLAT WASHER SECURE THE FRONT EVAPORATOR MOUNTING
BRACKET TO THE INNER COWL. SEE FIGURE 6 BELOW.
VERIFY THAT EVAPORATOR UNIT IS LEVEL AND SQUARE TO THE DASH, THEN TIGHTEN ALL MOUNTING BOLTS.
(NOTE: TIGHTEN THE BOLT ON FIREWALL FIRST, THEN THE FRONT MOUNTING BRACKET SCREWS.)
8
1969-70 MUSTANG w/o AC GEN IV
901271 REV A 2/11/08, 69-70 MUSTANG w/o AC GEN IV EVAP INSTR PG 8 OF 26
USE TEMPLATE PROVIDED ON PAGE 25. ALIGN TEMPLATE WITH OEM BLOWER MOTOR MOUNTING
HOLES & DRILL (6) 3/16 HOLES IN FIREWALL FROM INSIDE UNDER DASH, SEE FIGURE 5a.
FIGURE 5
FIGURE 5a
EVAP
FRONT
BRK
T
641
271
DRIVER SIDE EVAP
MOUNTING HOLE
FIGURE 6
(2) #
14 X
3/4
SHE
ETMET
AL
SCREW
w/ 1
/4
FLA
T W
ASHER
PASSENGER SIDE EVAP
MOUNTING HOLE
S
B
Y
1969-7
0 MUST
ANG w/o AC
FIREWALL COVE
R
HOLE TEMPL
ATE
THIS SIDE IN
SIDE OF CAR
(6) 3/16
HOLES
OEM HEATER
HOLE
BLOWER MOTOR
MOUNTIN
G
HOLE
BLOWER
MOTOR
MOUNTIN G
HOLE
BLOWER
MOTOR
MOUNTIN G
HOLE
BLOWER
MOTOR
MOUNTIN G
HOLE
(4) ALIG
NMENT HOLES
OEM HEATER
LINE HOLES
DRIVER SIDE EVAP
MOUNTING HOLE
PASSENGER SIDE EVAP
MOUNTING HOLE
