153
Index
1/18/06 Z4Mplus/Z6Mplus User Guide 13163L-001 Rev. A
I
idle display setting, 94
images list, 79
initialize Flash memory, 82
initialize memory card, 81
inspect for shipping damage, 15
install memory card, 65
interfaces
IEEE 1284 bidirectional parallel, 21
print servers, 21
RS-232 serial, 20
international safety organization marks, 18
IP settings
default gateway, 98
IP address, 97
protocol, 97
subnet mask, 97
L
label length maximum setting, 78
label sensor positioning, 59
label top
printer cannot detect, 124
setting, 92
labels did not print, 122
language
changing from unreadable language, 123
selection, 95
LCD error messages, 115
LCD messages
adjust LCD settings, 93
language selection, 95
Setup mode, 73
liability, ii
liner removal
liner take-up mode, 39
Rewind mode, 50
liner take-up mode
liner removal, 39
list settings
all settings, 80
bar codes, 79
fonts, 79
formats, 79
images, 79
network, 80
setup, 80
load factory defaults, 69
loading media
Cutter mode, 40
Peel-Off mode, 34
Rewind mode, 44
Tear-Off mode, 31
loading ribbon, 53
lubrication, 102
M
MAC address, 98
manual calibration, 58
mark LED setting, 93
Mark Med S. setting, 93
maximum label length setting, 78
media
continuous roll media, 24
fanfold, 24
loading, 28
media LED setting, 93
non-continuous roll media, 23
ordering, 3
RFID “smart” labels, 24
setting media type, 75
specifications, 145
types of media, 23
media and ribbon sensor calibration procedure, 84
media compartment
cleaning, 105
components, 12
media door, 8
media loading
Cutter mode, 40
Peel-Off mode, 34
Rewind mode, 44
Tear-Off mode, 31
media power up setting, 90
Media S. setting, 93
media scratch test, 25
media sensor
print sensor profile, 83
reflective sensor adjustment, 61
media sensors
transmissive sensor location, 59
memory card
installation, 65
modem connection, 139
