7
8
9
10
CLACK
11
CLACK
Water inlet filters
To clean, proceed as follows :
Precautions to be taken against frost
If your appliance is exposed to temperatures be-
low 0°C, the following precautions must be tak-
en:
• Close the tap and disconnect the inlet hose.
• Place the end of this hose and the drain hose
in a basin on the floor.
• Select the Drain programme let it run until the
end of the cycle.
• Disconnect the appliance from the power
supply by turning the programme selector to
“Stop”
.
• Unplug the appliance.
• Replace the inlet hose and drain hose.
This way, the water remaining in the hoses will
be drained away, avoiding any ice formation
which would damage your appliance.
Before turning your appliance on again, ensure
that it is installed in an area where the tempera-
ture will not fall below freezing.
NOTE ! This machine is made for use in normal
inside temperature. Manufacturer is not respon-
sible for freezing damages.
Operating Problems
Numerous checks were carried out on your ap-
pliance before it left the factory. However,
should you notice a malfunction, please refer to
the sections below before contacting the after-
sales service.
Problems Causes
The appliance doesn’t start
or doesn’t fill:
• the appliance isn’t plugged in correctly, the electrical installation isn’t working,
there is a power failure,
• the lid of your appliance and the drum shutters aren’t closed firmly,
• the programme start command hasn’t been properly selected,
• the water supply has been cut off, the water inlet tap is closed,
• the water inlet filters are dirty (see “Care and cleaning ”).
The appliance fills but
empties straight away:
• the drainage U-piece is fixed too low (see “Installation”).
10
www.zanussi.com
