- 18 -
Levelling the machine
Level the washing machine by loosening or tightening
the feet. Accurate levelling prevents vibration, noise and
displacement of the machine during operation. After
levelling the machine, secure the feet by tightening the
ring nuts (Fig. 1).
Some vibration is inevitable, especially if mounted on a
wooden floor.
Sprung wooden floors are particularly susceptible to
vibration. For advice, consult a builder. If possible,
always place the machine on a solid floor.
Special conditions
If the floor is carpeted with a deep-pile carpet or
covered with crumbly or soft material, insert a rigid
support base under the feet to prevent noise, vibration
or displacement. The base should protrude a few
centimetres beyond the edges of the machine.
The machine should not be placed on deep
pile carpeting.
Note
Please ensure that when the appliance is installed it is
easily accessible for the engineer in the event of a
breakdown.
All plumbing and electrical work required to install this
appliance must be carried out by competent persons or
qualified plumbers or electricians.
Water inlet
Insert the combination rubber washer/filter and
connect the inlet hose to a tap with a 3/4" pipe thread
(Fig. 2).
The intake hose must not be joined onto any form of
extension hose. If it is too short, the entire hose must be
replaced with a longer high-pressure hose, specially
designed for the purpose.
The machine end of this hose can be turned in any
direction. Loosen the retaining nut, turn the hose, then
retighten the nut (Fig. 3).
2
3
1
