Water hardness Adjusting the water hardness
setting
Use of salt
°dH °TH mmol/l manually electronically
4 - 10 7 - 18 0,7 - 1,8 1 level 2 yes
< 4 < 7 < 0,7 1 level 1 no
The water softener must be set in both ways:
manually, using the water hardness dial and
electronically.
Setting the water softener manually (see table)
Set switch to position 1 or
2
The water softener is factory set at position 2.
Setting the water softener
electronically (see table)
The dishwasher is factory set at level 5.
1. Press the On/Off button. The dishwasher
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C until the lights of the func-
tion buttons A, B and C start flashing.
3.
Press function button A, the lights function
buttons B and C turn off while the light of
function button A goes flashing, at the
same time the end of programme indica-
tor light starts to flash, along with a se-
quence of intermittent audible signals. The
current level is indicated by the number of
flashes of the end of programme indicator
light with a sequence of intermittent audible
signals and a pause of a few seconds.
Examples:
5 flashes / 5 intermittent audible signals,
pause,
5 flashes / 5 intermittent audible signals,
pause, etc...= level 5
6 flashes / 6 intermittent audible signals,
pause,
6 flashes / 6 intermittent audible signals,
pause, etc...= level 6
4. To change the level press the function but-
ton A. Each time button is pressed the level
changes (For the selection of a new level
see the chart).
Examples:
10
