• mmol/l (millimol per litre - international unit for the
hardness of water).
•Clarke.
Adjust the water softener in to the water hardness in your
area. If necessary, contact your local water authority.
Water hardness Water hardness setting
°dH °TH mmol/l Clarke manually electronically
51 - 70 91 - 125 9,1 - 12,5 64 - 88 2 10
43 - 50 76 - 90 7,6 - 9,0 53 - 63 2 9
37 - 42 65 - 75 6,5 - 7,5 46 - 52 2 8
29 - 36 51 - 64 5,1 - 6,4 36 - 45 2 7
23 - 28 40 - 50 4,0 - 5,0 28 - 35 2 6
19 - 22 33 - 39 3,3 - 3,9 23 - 27 2 5
15 - 18 26 - 32 2,6 - 3,2 18 - 22 1 4
11 - 14 19 - 25 1,9 - 2,5 13 - 17 1 3
4 - 10 7 - 18 0,7 - 1,8 5 - 12 1 2
< 4 < 7 < 0,7 < 5
1
1)
1
1)
1) No use of salt required.
You must set the water softener manually and elec-
tronically.
Manual adjustment
The appliance is set at the factory at position 2.
1 2
Set switch to position 1 or
2.
Electronic adjustment
The water softener is set at the factory at level 5.
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold function buttons B and C until the
indicator lights for function buttons A, B and C start
to flash.
4. Release function buttons B and C.
5. Press function button A.
– The indicator light for function button A continues
to flash.
– The indicator lights for function buttons B and C
go off.
– The end indicator light starts to flash.
The setting function of the water softener is activated.
The end indicator light flashes to show the level of
the water softener. The pause is approximately 5 sec-
onds.
Example: 5 flashes, pause, 5 flashes, pause, etc... =
level 5
6. Press the function button A one time to increase the
water softener level by one step.
7. Press the on/off button to save the operation.
Use of dishwasher salt
Caution! Only use dishwashers salt. Types of salt that are not applicable for dishwashers cause damage to
the water softener.
21
