Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not suf-
ficient. Adjust the rinse aid selector to a
higher position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying phase or
with a low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent tablets
can be the cause. Try a different brand or
activate the rinse aid dispenser and use
rinse aid together with the combi detergent
tablets.
Refer to ‘HINTS AND TIPS’ for other pos-
sible causes.
How to activate the rinse aid dispenser
1. Press the on/off button to activate the ap-
pliance. Make sure that the appliance is in
setting mode, refer to “Setting and starting
a programme”.
2. Turn the programme knob until the pro-
gramme marker is aligned with
.
3. Press and hold, at the same time, Multi-
tab and Delay until the indicators
,
, and start to flash.
4. Press Delay.
•
The indicators
and go off.
•
The indicator
continues to flash.
• The display shows the current setting of
the rinse aid dispenser.
Off
On
5. Press Delay again and again to change
the setting.
6. Press the on/off button to deactivate the
appliance and to confirm the setting.
Technical information
Dimensions Width / Height / Depth (mm) 600 / 850 / 625
Electrical connection Refer to the rating plate.
Voltage 220-240 V
Frequency 50 Hz
Water supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )
Water supply
1)
Cold water or hot water
2)
max. 60 °C
Capacity Place settings 12
Power consumption Left-on mode 0.99 W
Off-mode 0.10 W
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian energy), use the hot
water supply to decrease energy consumption.
12
www.zanussi.com
