Water hardness
Adjusting the water hardness
setting
Use of salt
°dH °TH mmol/l manually electronically
4 - 10 7 - 18 0,71 - 1,8 1 level 2 yes
< 4 < 7 < 0,7 1 level 1 no
Setting the water softener manually (see table)
Set switch to position 1 or
2
The water softener is factory set at position 2.
Setting the water softener electronically (see table)
The water softener is factory set at position 5.
1. Press the On/Off button. The appliance
must be in setting mode.
2. Press and hold Programme selection/
RESET button until programme light A
flashes and programme light B illuminates
with fixed light.
3. After a few seconds:
–
programme light B turns off
– programme light A goes on flashing
–
End of programme light starts flashing:
the number of flashes corresponds to
current level set. The flashing is repea-
ted with a pause of a few seconds. Ex-
amples: 5 flashes, pause, 5 flashes,
pause, etc... = level 5.
4.
To change the level, press the Programme
selection/RESET button. Each time the
button is pressed the level increases (level
1 follows level 10). The End of pro-
gramme light indicates the new setting.
5. To memorise the operation, switch off the
dishwasher.
Use of dishwasher salt
CAUTION!
Use only special salt suitable for dishwashers.
82
