D
A
5
Put filter (A) to its initial
position. Make sure that
it assembles correctly un-
der the two guides (D).
6
Assemble filters (B) and
(C). Put them into posi-
tion in filter (A). Turn the
handle clockwise until it
locks.
An incorrect position of the filters can cause bad
washing results and damage to the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, remove re-
maining parts of soil with a thin pointed object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abrasive prod-
ucts, abrasive cleaning pads or solvents.
Troubleshooting
The appliance does not start or it stops during opera-
tion.
Before you contact the Service, refer to the information
that follows for a solution to the problem.
With some problems, different indicators flash con-
tinuously or intermittently at the same time to show
an alarm code.
Alarm code Problem
• The indicator of the set programme flashes continu-
ously.
• The end indicator flashes 1 time intermittently.
The appliance does not fill with water.
• The indicator of the set programme flashes continu-
ously.
• The end indicator flashes 2 times intermittently.
The appliance does not drain the water.
• The indicator of the set programme flashes continu-
ously.
• The end indicator flashes 3 times intermittently.
The anti-flood device is on.
Warning! Deactivate the appliance before you do
the checks.
Problem Possible solution
You cannot activate the appliance. Make sure that the mains plug is connected to the mains sock-
et.
Make sure that there is not a damaged fuse in the fuse box.
The programme does not start. Make sure that the appliance door is closed.
If the delay start is set, cancel the setting or wait for the end of
the countdown.
23
