8825/8830 Controller Setup Manual for Firmware 6.0 ii
Safety Information (continued)
Unplug the printer from the wall outlet and refer servicing to qualified service
personnel under the following conditions:
• When the power cord is damaged or frayed.
• If liquid has been spilled into the product.
• If the controller has been exposed to rain or water.
• If the printer is producing unusual noises or odors.
• If the printer or the cabinet has been damaged.
• If you need additional safety information concerning the Controller or
supplied materials, you may call the Xerox Engineering Systems.
Ground Fault Protection
The 8825/8830 Engineering Printer is equipped with an additional safety
feature, a Ground Fault Interrupter (GFI). This safety device will remove all
power to the printer if an electrical fault is detected.
In the event that power is interrupted to the printer, locate the GFI safety
device below the AC power switch.
Check that a red indicator appears in the window (A) of the safety device
shown below. Note: On your Controller this may be a circuit breaker.
If no indicator is present, press and release the black RESET button (B).
The red indicator should appear in the window, and power should be
restored to the printer. Note: If equipped with a circuit breaker, reset the
breaker (or turn on the Controller) by pressing the BLACK button.
If the device interrupts power to the printer again, or if power is not restored
by performing the above procedure, call Xerox Engineering Systems to
correct the problem.
B
A
