8825/8830 Controller Setup Manual for Firmware 6.0 115
Configuring the Printer Processing Defaults (continued)
Setting the Raster Stamp Option
A raster stamp is an image file that is stored on the printer’s hard drive under
a user-defined name created and sent to the printer by use of the Printer
Manager Tool software.
Purpose of Raster Stamp Option
When this option is set to NONE, a default raster stamp will not be applied
during printing. When this option is set to a raster stamp file name, if a
specific stamp is not defined by the print job itself, the named default raster
stamp will be printed. The raster stamp size and the position on the print is
user-defined. 10MB of disk space is available on the Hard Drive for Raster
Stamp storage.
Range: NONE, or a file name of up to 32 characters.
Default: NONE
Note: To support any raster stamp files at the controller, the controller
must be equipped with the hard drive option.
PATH TO SET THE RASTER STAMP OPTION
Display <IDLE>, press [ON-LINE], display <PAUSED>, press [ENTER],
display <UTILITIES>, pr
ess [NEX
T] until <PRO
CESSING DEFAULT
S> is
displayed, press [ENTER], display <ELECTRONIC COLLATION>, press
[NEXT] until <RASTER STAMP> is displayed.
SELECTING THE RASTER STAMP OPTION
Press the ENTER key to enter the RASTER STAMP menu. Press NEXT to
display <ID>. Press ENTER and NEXT to select a stamp. When the desired
selection is displayed, press the ENTER key.
EXITING THE RASTER STAMP OPTION
Press EXIT to set up additional functions. Press the ON-LINE key to go back
to ON-LINE mode.
