SETTING UP THE INTEGRATED FIERY COLOR SERVER FROM THE DIGITAL PRESS
CONTROL PANEL
37
Depending on your selection, configure the appropriate options, as follows:
Enable IPv6
Select this option to allow the Integrated Fiery Color Server to retrieve an IPv6 address from
the network.
If you choose Automatic If you choose Manual
Protocol
DHCP, BOOTP
Choose the protocol over which the Integrated
Fiery Color Server searches for its IP address. Both
DHCP and BOOTP allow the Integrated Fiery
Color Server to obtain the Ethernet IP address
and subnet mask automatically.
NOTE: Depending on your network, the
Integrated Fiery Color Server might be assigned a
different address after you restart the Integrated
Fiery Color Server. With the DHCP setting, the
Integrated Fiery Color Server can be assigned a
different address even if it is not restarted. Make
sure the network is already configured properly for
the protocol you select.
IP Address
127.0.0.1
Enter the Integrated Fiery Color Server IP address
for Ethernet. This IP address, unlike an IP address
set automatically, remains the same if you restart
the Integrated Fiery Color Server. You must
change the default to a valid address for your
network. For information about setting up
printing with TCP/IP, see page 12.
Subnet Mask
255.255.255.0
Set the subnet mask for printing with TCP/IP on
your network.
NOTE: Confirm the subnet mask setting with
your network administrator before proceeding.
Gateway Type
Automatic, Manual
Choose the method for obtaining the gateway
address for printing with TCP/IP.
Gateway Address
127.0.0.1
Set the gateway address for printing with TCP/IP
on your network.
Gateway Address
127.0.0.1
If you answered Manual to the previous option,
set the gateway address for printing with TCP/IP
on your network.
