XEROX DOCUPRINT 180 LPS OPERATOR GUIDE 12-1
12. 12Problem solving tasks
This chapter contains instructions for diagnosing and solving
common problems that may arise when operating the LPS. Also
included are instructions for placing a service call, when needed.
LPS problems
The following sections deal with LPS problems.
Fault masking and the printer control console
The Xerox DocuPrint 180 LPS allows you to continue printing while
certain faults or conditions exist in areas of the printer not currently
being used. The LPS does this by “masking” the fault or condition
and continuing to print the current job. For example, if you are
printing a report using feeder tray 1 and stacking into stacker bin A,
the LPS continues printing even if a jam exists in feeder tray 2 or if
stacker bin B is full. Whenever there is a masked fault or condition,
the Hint icon (a light yellow circle with an asterisk inside) appears on
the printer control console and the Attention light goes on. If a
condition is being masked, such as low dry ink, a message also
appears in line 3 of the message area of the printer control console.
The message is preceded by an asterisk. In the case of either a
masked fault or condition, the Hint icon appears on the PC UI and a
message appears in the Messages window. To display the area
containing the masked fault (for example, the location of the paper
jam), touch the Fault List icon on the printer control console.
The Fault List screen appears. (See figure 12-1.)
